This is the first thing that popped in my mind with the headline 🤣

Today was an oat milk latte made with Spella Cafe’s signature roast espresso (probably my favorite espresso roaster)

I have a kingrinder, and been “dabbing” my beans with a spritz of water for the last 6 months or so. So far it hasn’t had any noticeable affects other than making cleanup much easier.

That’s just my two cents though

If you’re only trying to clean of particles stuck to the burrs after each grinding session, I would recommend doing some kind of “RDT” (basically getting a few drops of water on the beans before they go into your grinder). This helps to minimize the static cling that the beans have.

With all things coffee, Hoffman has a nice video on it.

https://m.youtube.com/watch?v=T0Dh1W40ILY

That’s a fun arty favor, I love being able to print silly little toys for the kids that they cannot find on the shelf. Sure, it’s a mother silly plastic thing, but I made it for them and that’s neat imo

Have you looked at the voron machines? They come in either a self-sourced or kit form and you build it from the ground up.

The sibor or fystec V0.2 kits often can go on sale for less than 400 on Ali-express.

The best part about these builds is the community and the dedication to making fantastic printers to at you can build and learn with.

Before even using the deck I updated it, pre-downloaded the steamos onto a usb drive.

The install was very straightforward, highly recommended the upgrade. My only regret is is didn’t get the 1Tb drive