I’d say your print time per layer might be too high, aince the filament looks to be contracting off of the plate as it cools. I’d see if there was a way to speed-up the print time of each layer, or break up the plate’s large surface area with holes or other features to dissapate the stress as it cools.
- 0 Posts
- 195 Comments
Joined 2 years ago
Cake day: March 20th, 2024
You are not logged in. If you use a Fediverse account that is able to follow users, you can follow this user.
1·4 days agoTACO? Must be Tuesday…
4·4 days ago“Dicks out for Jesus Any%” runs, when?
Our group has basically dropped GW’s rulesets for OnePageRules variants, specifically Grimdark Firefight as a Killteam replacement. There’s a built-in army builder and faction equivalents for just about every GW faction.
While not killteam, we used their base Grimdark to play a full 2v2 500pt game in less than 3 hours.
The best part of all of this is that there’s no tracking of individual armies unique tactical options, everyone is using the same ruleset that uses a combined set of tactical options available to everyone. You can evem do- interfactional armies!
It’s a Chiaotzu!
Nothing says “Death Cult” quite like the prominant display of the murder weapon used against their leader.
11·1 month agoIt’s almost like it’s a suicidal death-cult.
3·1 month agoI mean, the Israelis kind of had something similar for a bunch of pagers, but instead of bricking the device, they just violently exploded.
Pretty sure most of the Walking Dead cast would never have survived an initial outbreak of gingivitis, let alone zombies…
2·2 months agoI think they should add the word “Fuck” to all age verification prompts until they, too, get censored.
If the insurance firm has a lot of money to throw at constant adds, then odds are good that they aren’t paying out premiums for their customers.
They were always sacrificial pawns. The administration has been salivating over one of them getting killed so that they can invoke Artical 2 and call for martial law.
Fun Crow facts: Crows have been known to investigate deaths of their fellow crows and can hold generational grudges!
Text has been a little sluggish with my tests. Might be due to influx of users, though.
Were you playing online? There was a bug a while back that could cause players in the same instance to all take damage if one player did.
1·3 months agoNo sympathy after their warrentless siezure of a Windscribe VPN server a day ago.
3·3 months agoIt’s quite warm on/near the Pacific right now.
1·3 months agoAre those numbers accurate? The latest release I’m seeing on that page is listed as being in 1997.
1·3 months agoHate week is a time-honored tradition!
I was referring to the waveyness in the center, though the warping on the esges is partly caused by both the oils and the cooling shrinkage, I believe.
The uniform buckling of the layer in the middle of the sheet is what I’m leaning on, but I don’t believe that your fan speed is too high, or there would be more seperation between layers as the filament would cool too much before adhering to the layer below.
I believe there are test STLs that assist in Dialing in your settings for printing plates in particular, but I’m avoiding printing surfaces that large until I get an enclosure built.